![]() Then cut off the excess strands with a sharp knife. This will ensure that the strands are tightly married to the strands and you will be able to see the evenness of your work. 3 to 4 passes ensure good resistance FinishĪfter making sure that everything is in order, that each strand goes to the right place and that the splice is tight, twist the rope firmly at your splice. Three to four passes will ensure that the eye is as strong as the rope itself. Tighten well at the end of each pass and continue twisting the strands on themselves to give a nice look and maximum strength to the whole. Then continue braiding in the same fashion, making sure to go over one strand before going under the next. At this point, the tape is no longer necessary and can be removed. At the end of the first pass, tighten the assembly and check by turning the rope that each strand passes under the right strand and that they come out forming a 120° angle between them. Keep the strand well twisted between thumb and forefinger The strands on top euros underneathĭo the same for the other two strands, following the most natural path. If the result is not fully satisfactory, retwist the strand before the progress of the work no longer allows it. ![]() To ensure a clean job, try to keep the strand well twisted between two fingers. Twisting the strand will open up and make it easier to pass. Pass the strand under a strand of the rope. Proper placement of the strands is a guarantee of success First pass To help you during the first tests, we recommend tying the 2 free strands under the rope while you slide the third one in place. They should be held like this during the first pass. Place the loose strands against the rope, one on top and the other two on either side. With the rope, form an eye to the desired size. The adhesive helps a lot at the beginning Create the eye of the rope If the ends of the strands tend to fray, heat them with a soldering iron. Place a strip of tape about 20 centimeters from the end of the rope and untwist it to that stop. If that's not enough, the flame of a lighter will do the trick. Get a good knife, a roll of tape and a soldering iron to burn the ends of synthetic ropes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |